Lopi Revere User Manual download pdf (Page 10)

10 Stove Installation (for qualified installers only)

Zero-Clearance (Metal) Fireplace Requirements

• Must utilize a positive (full reline) or direct connection (block-off plate)

• Must be manufactured by one of the following manufacturers:

• Marco • Majestic • Heatilator • Preway • Tempco • Superior

• Entire fireplace, including chimney, must be clean and undamaged. Any damage must be repaired

prior to installation of the insert

• Entire fireplace, including chimney, must meet local building requirements

• Chimney height: 15' minimum; 33' maximum. Minimum cross section: 28.65 square inches

• The damper ("A") and grate ("B") must be removed (see Figure 4). The smoke shelf ("C"), internal

baffles ("D"), screen ("E"), and metal or glass doors ("F") may be removed (if applicable). The

masonry lining ("G"), insulation ("H"), and any structured rigid frame members (metal sides, floor, door

frame, face of the fireplace, etc. – "I") may not be removed or altered

Figure 4

Drafting Performance

This appliance relies upon natural draft to operate. External forces, such as wind, barometric pressure,

topography, or factors of the home (negative pressure from exhaust fans, chimneys, air infiltration, etc.),

may adversely affect draft. Travis Industries can not be responsible for external forces leading to less

than optimal performance.

Leveling Bolt Installation

Two leveling bolts are included to level the insert if the fireplace has a stepped-up hearth. To install, raise

the rear of the insert up and insert the leveling bolts into the holes in the rear corners of the insert. Adjust

the bolts until they extend the same height as the hearth steps up. After the insert is installed, fine-tune

the leveling bolts to level the insert (see Figure 5).

This distance is the

hearth step-up. The

leveling bolts should

stick out this far from the

base of the insert.

Fireplace

Hearth

The leveling bolts go

into the holes at the

rear corners of the

insert.

Figure 5

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 33 34

No comments

Lopi Revere User Manual Page 10