Lopi Yankee PS User Manual download pdf (Page 25)

Operation 25

Start-Up Sequence

This stove utilizes a start-up sequence whenever the mode switch is changed or the heater is started

when cold. This is to ensure proper operation through all possible settings and operational states (hot

or cold, pellets burning or not burning, etc.). This sequence over-rides all user settings (except the

"OFF" position) to set the auger feed rate to medium, the exhaust blower to high, and the igniter on.

During this period the lowest “HEAT OUTPUT” light will flash.

"AUGER ON" Light

This light comes on when the auger is turning. This allows the operator to determine when the auger

is turning.

"FAULT" Light

NOTE : If the “FAULT” light comes on, check

the items below before calling for service .

The “FAULT” light is used to indicate

maintenance is required on the heater. It will

turn on due to various operating

circumstances. When the fault light turns on, a

second light will turn on near “HEAT OUTPUT”

(see the illustration to the right). When the fault

light turns on, determine the fault code (2, 4, or

6), then use the chart below to diagnose and

remedy the situation.

HIGH

DISCONNECT POWER BEFORE SERVICE

REMOTE

AUTO

MANUAL

MED

LOW

AUGER

FAULT

# 6 Light

(red)

# 2 Light

(green)

# 4 Light

(yellow)

Light Likely Cause Remedy

(green)

• Heavy Ash Build-Up in Exhaust Duct

• Heavy Ash Build-Up in Exhaust

Housing or Plugged Tubing

• Heavy Ash Build-Up in Vent

• Clean the Firebox (see page 34)

• Clean the Exhaust Housing and Tubing (see page

35)

• Clean the Vent (see page 35)

(yellow)

• Heater Ran Out of Pellets

• Heater Did Not Start-Up Correctly

• Power Outage

• Restrictor Not Set Properly

• Burnpot Clogged

• Air Leak

• Heavy Ash Build-Up

• Auger Drop Tube Plugged

• Refill the Hopper (see page 21)

• Re-Start the Heater and Verify the Pellets Ignite

after 10 Minutes

• Re-Start the Heater (see page 26)

• Re-Start the Heater and Monitor Restrictor

Setting (see page 24)

• Clean Burnpot (see page 28)

• Verify Door, Glass, and Ashpan Seal Correctly

(see page 37)

• Clean the Firebox (see page 34), Exhaust

Housing (see page 35), and Vent (see page 35)

• Clear the Auger Drop Tube (see page 29)

(red)

• Electrical Input Error (voltage or mhz

fluctuation, amp deficiency, etc.)

• Components Over-Heated

• Faulty Wiring / System Fault

• Unplug the Heater then Plug it Back In (this re-

starts the circuit board)

• Clean the Heater and Vent (a plugged heater will

slow exhaust flow, increasing temperatures –

see pages 34- 35)

• If this Fault Persists, Contact Your Dealer

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 41 42

Comments to this Manuals

No comments

Lopi Yankee PS User Manual Page 25

Comments to this Manuals

Related products and manuals for Tools Lopi Yankee PS